Siemens CU230P-2 HVAC Parameter Manual page 37

r0203[0...n] Actual power unit type / PU actual type
Access level: 3
Unit: -
Description: Displays the type of power unit found.
Value: 2:
3:
4:
5:
6:
7:
100:
101:
102:
112:
113:
114:
115:
116:
118:
120:
150:
200:
250:
260:
300:
350:
400:
Note: For parallel circuit configurations, the parameter index is assigned to a power unit.
r0204[0...n] Power unit hardware properties / PU HW property
Access level: 3
Unit: -
Description: Displays the properties supported by the power unit hardware.
Bit field: Bit Signal name
01 RFI filter available
07 F3E regenerative feedback into the line sup-
ply
08 Internal Braking Module
12 Safe Brake Control (SBC) supported
14 Internal LC output filter
p0205 Power unit application / PU application
PM230 Access level: 1
Can be changed: C(1, 2)
Min
0
Description: The duty cycles can be overloaded provided that the drive converter is operated with its base load current before
and after the overload. This is based on a load duty cycle of 300 s.
Value: 0:
1:
Notice: The parameter value is not reset when the factory setting is restored (see p0010 = 30, p0970).
Note: When the parameter is changed, all of the motor parameters, the technological application and the control mode
are pre-assigned according to the selected application. The parameter has not influence when calculating the ther-
mal overload.
p0205 can only be changed to the settings that are saved in the power unit EEPROM.
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
MICROMASTER 440
MICROMASTER 411
MICROMASTER 410
MICROMASTER 436
MICROMASTER 440 PX
MICROMASTER 430
SINAMICS S
SINAMICS S (value)
SINAMICS S (combi)
PM220 (SINAMICS G120)
PM230 (SINAMICS G120)
PM240 (SINAMICS G120)
PM250 (SINAMICS G120)
PM260 (SINAMICS G120)
SINAMICS G120 Px
PM340 (SINAMICS S120)
SINAMICS G
SINAMICS GM
SINAMICS SM
SINAMICS SM120
SINAMICS GL
SINAMICS SL
SINAMICS DCM
Load duty cycle with high overload for vector drives
Load duty cycle with low overload for vector drives
Calculated: -
Scaling: -
Calculated: -
Scaling: -
1 signal
Yes
Yes
Yes
No
Yes
Calculated: -
Scaling: -
Max
1
Parameters
List of Parameters
Data type: Integer16
Data set: PDS
Data type: Unsigned32
Data set: PDS
0 signal
No
No
No
Yes
No
Data type: Integer16
Data set: -
Factory setting
1
FP
-
-
-
-
-
1-37