Siemens CU230P-2 HVAC Parameter Manual page 324

Parameters
List of Parameters
p8725[0...4] CAN Transmit PDO 6 / Transmit PDO 6
CU230P-2 CAN Access level: 3
Can be changed: C(3), T
Min
0000 hex
Description: Sets the communication parameters for CANopen Transmit Process Data Object 6 (TPDO 6).
Index: [0] = PDO COB-ID
[1] = PDO transmission type
[2] = Inhibit time (in 100 µs)
[3] = Reserved
[4] = Event timer (in ms)
Dependency: A valid COB-ID can only be set for the available (existing) channel.
Refer to: p8741
Notice: For inhibit time and even timer, the following apply:
A value that is not a multiple integer of CANopen (4 ms) is rounded-off.
Note: Corresponds to the CANopen object 1805 hex + 40 hex * x (x: Drive number 0 ... 7).
Transmission types 0, 1 ... F0, FE and FF can be set.
PDO: Process Data Object
p8726[0...4] CAN Transmit PDO 7 / Transmit PDO 7
CU230P-2 CAN Access level: 3
Can be changed: C(3), T
Min
0000 hex
Description: Sets the communication parameters for CANopen Transmit Process Data Object 7 (TPDO 7).
Index: [0] = PDO COB-ID
[1] = PDO transmission type
[2] = Inhibit time (in 100 µs)
[3] = Reserved
[4] = Event timer (in ms)
Dependency: A valid COB-ID can only be set for the available (existing) channel.
Refer to: p8741
Notice: For inhibit time and even timer, the following apply:
A value that is not a multiple integer of CANopen (4 ms) is rounded-off.
Note: Corresponds to the CANopen object 1806 hex + 40 hex * x (x: Drive number 0 ... 7).
Transmission types 0, 1 ... F0, FE and FF can be set.
PDO: Process Data Object
1-324
Calculated: -
Scaling: -
Max
C000 06DF hex
Calculated: -
Scaling: -
Max
C000 06DF hex
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Data type: Unsigned32
Data set: -
Factory setting
C000 06DF hex
Data type: Unsigned32
Data set: -
Factory setting
C000 06DF hex
© Siemens AG 2009 All Rights Reserved