Mipsend, Send Data; Mipsend Parameters - Motorola AT Commands G24-L Developer's Manual

GPRS
+MIPSETS: (1-4),(1-1372)
OK
AT+MIPSETS?
+MIPSETS: 1,100
+MIPSETS: 2,1372
OK

+MIPSEND, Send Data

This command causes the G24-L to store the data that the terminal provides in the accumulating
buffer, and then send this data using an existing protocol stack when the amount of data reaches
the predefined amount (see
sending data, a valid connection must be created using the +MIPCALL and +MIPOPEN
commands.
Motorola recommends that the terminal sets the watermark in the accumulating buffer prior to
this command, using the +MIPSETS command. By default, the watermark is set to 1372 bytes of
data.
Command Type
Set
Read
Test
The following table shows the +MIPSEND parameters.
<Parameter>
<socket ID>
<Free Size>
<Data>
3-284
//Information provided only for active sockets
//Information provided only for active sockets
"+MIPSETS, Set Size for Automatic Push" on page
Syntax
+MIPSEND = ERROR
<Socket
Or:
ID>,<Data>
+MIPSEND= <Socket ID>,<Status>,<Free
Size>
+MIPSEND? +MIPSEND <Socket ID>,<Free
Size>>[<Socket ID> <Free
Size>]<CR><LF>
For all ACTIVE sockets.
+MIPSEND=? ERROR
Table 3-200: +MIPSEND Parameters
1,2,3,4 Number of valid socket
Free space in current buffer. Free size is calculated from the 1372.
0 < Free Size < 1372
User data string is sent encoded with 0-F hexadecimal digits (String ends with a
<CR>)
G24-L AT Commands Reference Manual
Response/Action
Description
3-283). Before
Remarks
Data in the
+MIPSEND
command is limited
to 80 characters
(160 in coded
form).
<Status>:
0 - Success
1 - Socket is
flowed off
April 15, 2008