Vtd, Tone Duration; Vtd Parameters - Motorola AT Commands G24-L Developer's Manual

+VTD, Tone Duration

This command handles the selection of tone duration. An integer <n> defines the length of tones
emitted as a result of the +VTS command. This command does not affect the D (dial) command.
(Refer to
Any value other than zero causes a tone of duration <n> in multiples of 100 msec.
In this command, the new value is erased after power down.
Note:
Command Type
Set
Read
Test
The following table shows the +VTD parameters.
<Parameter>
<n>
Example
AT+VTD=?
+VTD: (0-600)
OK
AT+VTD?
+VTD: 5
OK
AT+VTD=10
OK
April 15, 2008
"D, Dial Command", page 11.)
In GSM, the tone duration value can be modified depending on the specific network.
Syntax
+VTD=<n>
+VTD?
+VTD=?
Table 3-117: +VTD Parameters
Defines the length of tones emitted by the +VTS command.
0-600 Multiples of 100 msec (0 is equivalent to 1, that is, 100 msec)
The default is 5 multiples of 100 msec.
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
OK The Set command sets the tone
duration.
+CME ERROR: <err>
<n> The Read command displays the
current tone duration.
+CME ERROR: <err>
+VTD: (list of The Test command displays the list of
supported tone durations.
supported <n>s)
+CME ERROR: <err>
Description
Remarks
3-175