Cmss Parameters - Motorola AT Commands G24-L Developer's Manual

SMS
Otherwise the message is sent to the DA it was stored with (if any was entered). If no DA is
found, an error occurs.
When the given index is an incoming message index the header settings will be as follows:
•
<first-octet> will be SMS-SUBMIT and VPF - relative.
•
The TP-RP and TP-UDHI settings will be taken from the incoming message's first octet.
•
<vp> - will be set to the default value -167 - as defined in 03.40.
•
<sca>,<tosca>, <pid> and <dcs> will be set according the incoming message parameters.
•
If <da> and/or <toda> are not given by the command, the <oa> and <tooa> will be set
instead.
Command Type
Set
The following table shows the +CMSS parameters.
<Parameter>
<index>
<da>
<toda>
<mr>
Example
AT+CMSS=7
+CMSS: 12
OK
AT+CMSS=7,"054565132",129
+CMSS: 13
OK
Note:
3-102
Syntax
+CMSS=<index>[
,<da>[,<toda>]]
Table 3-62: +CMSS Parameters
1-352 Index in storage of the message to be sent.
Destination address in quoted string. This field contains a single phone number.
Type of DA. Value between 128-255 (according to GSM 03.40, 9.1.2.5). If this field is
not given and first character of <da> is '+' , <toda> will be 145, otherwise 129.
S
ent message reference number.
Any character sent by TE to G24-L before G24-L has reported a result of AT+CMSS
operation, will abort AT+CMSS command execution. However, if SMS was already sent
to network and sending operation was successful, the result of operation "+CMSS <mr>"
will be reported by G24-L. If after aborting AT+CMSS command execution and before
result of operation was reported by G24-L, a second AT+CMSS command is executed,
then the result of the second AT+CMSS operation only will be reported by G24-L.
G24-L AT Commands Reference Manual
Response/Action
+CMSS: <mr> The Set command sends a message
from storage to the network.
or:
+CMS ERROR: <err>
Description
Remarks
April 15, 2008