Mdsi Parameters - Motorola AT Commands G24-L Developer's Manual

Phone Books and Clock
Command Type
Set
Read
Test
The following table shows the +MDSI parameters.
<Parameter>
<mode>
<type>, <type
text>
<cause>,
<cause text>
3-68
Syntax Response/Action
+MDSI=<mode> When mode is 1 and
SIM was invalidated or
deactivated: [+MDSI:
<type>, <cause>, <type
text>, <cause text>]
OK
+CME ERROR: <err>
+MDSI? +MDSI: <mode>
OK
+CME ERROR: <err>
+MDSI=? +MDSI: (list of
supported <mode>s)
OK
+CME ERROR: <err>
Table 3-38: +MDSI Parameters
0 Unsolicited indications off
1 Unsolicited indications on
0 "DEACTIVATE". SIM deactivate request was sent with <cause>
1 "GSM". Invalidate SIM for GSM services was sent with <cause>
2 "GPRS". Invalidate SIM for GPRS services was sent with <cause>
<cause> and <cause text> related to <type> = 0 ("DEACTIVATE"):
1 "Bad SIM"
<cause> and <cause text> related to <type> = 1 ("GSM") and <type> = 2 ("GPRS"):
0 "No reject cause"
2 "IMSI unknown in HLR"
3 "Illegal MS"
4 "IMSI unknown in VLR"
6 "Illegal ME"
7 "GPRS service not allowed"
8 "GPRS and non-GPRS services not allowed"
9 "MS identity cannot be derived by the network"
11 "PLMN not allowed"
12 "Location area not allowed"
13 "Roaming not allowed in this location area"
14 "GPRS services not allowed in this PLMN"
240 "Location update failure"
241 "Combined LU failure"
242 "Authentication and ciphering reject"
243 "Authentication reject"
244 "Attach failure"
G24-L AT Commands Reference Manual
Remarks
The following is the available mode
values for the Set command.
<mode> = 1 - Defines that unsolicited
+MDSI messages will be sent to the
DTE. If the SIM card was invalidated
or deactivated, the current status will
be sent to the DTE.
<mode> = 0 - No unsolicited message
is sent to the DTE.
The Read command queries the current
settings for <mode>
The Test command returns the possible
<mode> values.
Description
April 15, 2008