Empc, Unlocking Or Locking Subsidy Code - Motorola AT Commands G24-L Developer's Manual

OK
(Voice and data international calls barred, fax and SMS not barred.)
AT+CLCK="OI",2
+CLCK: 1,1
+CLCK: 1,2
+CLCK: 0,4
+CLCK: 0,8
OK

+EMPC, Unlocking or Locking Subsidy Code

This command is applicable for all types of Subsidy Lock types:
•
HPLMN only
•
Type 1 HPLMN and 1 IMSI digit
•
Type 2 HPLMN and 2 IMSI digits
•
Type 3 HPLMN and GID 1
•
Type 4 HPLMN and Range of IMSI digits
•
Type 5 First SIM Inserted
•
Type 6 First SIS Inserted (GID 1 or No action)
•
Type 7 First SIM Inserted (GID 1 or Range Setting)
•
Type 9 PLMN of first SIM Inserted
•
D2 SIM Lock
•
HPLMN that matches 1st SIM Inserted
•
Valid PLMN
•
Telefonica SIM Lock
•
Airtel SIM Lock
Once the subsidy unlock pin code is entered correctly to the unit, the unit is not locked any more.
In order to relock the unit a Reset action is requested. Other PLMN that will be inserted into the
unit when the first PLMN is locked will be transited to a Lock state and will not be permitted to
perform other non-basic commands except for +EMPC and emergency calls. An error code 284 -
"SIM is subsidy locked" will be returned if some non-basic commands were entered when the
first PLMN is locked. If the user exceeds the maximum password attempts (5 attempts), the unit
will be transited to a "penalty" state and only basic command will be permitted to perform and
emergency calls. This state is effective to duration 5 minutes. An error code 285 - "The phone is
in a penalty state" will be returned if non-basic command was entered in case of penalty state.
When penalty state is over the unit will be transited to a Lock state. Availability of subsidy lock
feature was determined only by the special flexing. If another flex was determined, the command
will return +EMPC: 3,0 for read command and +EMPC: 1,0 for set command.
April 15, 2008 G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
3-187