Table of Contents
Advertisement
Figure 66: Software License Key Data Entry
The user must enter the license key and click the 'Validate License Key' button to check that
the key is valid and program it to non-volatile memory.
A license key is programmed into each unit during production and can be found written on the
Configuration Data Summary Label which is attached to the Quick Start Guide. If subsequently
the license key has been mislaid, replacement keys can be applied for online.
If a valid license key is not detected in the unit's non-volatile memory, the user is prompted to
enter a valid key. It should be noted that the 30/60 Mbps Backhaul units are shipped as link
pairs and as such, valid license keys are entered during the production process. Hence, the
user should never see the Software License Key screen (Figure 66).
To enter a license key simply type or paste the license key into the data entry box and press
the 'validate license key' button.
If a valid license key is detected then the user will be presented with a message to say that the
key is valid and that the system needs rebooting, as shown in Figure 67.
Issue 3.1, July 2006
Page 102 of 162
Advertisement
Table of Contents
