Motorola AT Commands G24-L Developer's Manual page 273

<Parameter>
<err>
Continued
Note:
April 15, 2008
Table 3-140: +CME Errors (Cont.)
111, "PLMN not allowed (#11)"
112, "Location area not allowed (#12)"
113, "Roaming not allowed in this location area (#13)"
132, "service option not supported (#32)"
133, "requested service option not subscribed (#33)"
134, "service option temporarily out of order (#34)"
147, "long context activation"
151, "GPRS disconnection timer is active"
149, "PDP authentication failure"
150, "invalid mobile class"
148, "unspecified GPRS error"
256, "too many active calls"
257, "call rejected"
258, "unanswered call pending"
259, "unknown calling error"
260, "no phone num recognized"
261, "call state not idle"
262, "call in progress"
263, "dial state error"
264, "unlock code required"
265, "network busy"
266, "Invalid phone number"
267, "Number Entry already started"
268, "Cancelled by user"
269, "Number Entry could not be started"
280, "Data lost"
281, "Invalid message body length"
282, "inactive socket"
283, "socket already open"
+CME ERROR:280, Data lost, is sent to the terminal in extreme cases when the G24-L
has to transmit data to the terminal and the buffers are full (Flow control Xoff status).
This error occurs when:
• An unsolicited indication (such as RING, +CLCC and so on) encounters the Xoff
status. When the flow control status returns to Xon, Error 280, Data lost, is sent to the
terminal instead of the unsolicited indication.
• An initiated AT command is waiting for a response, and the response encounters the
Xoff status.
When the flow control status returns to Xon, the AT command is aborted (if not yet
aborted) and Error 280, Data lost is sent to the terminal instead of OK (and the missing
data).
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
3-209