Sidetone - Motorola AT Commands G24-L Developer's Manual

At commands reference manual
Hide thumbs Also See for AT Commands G24-L:
Table of Contents

Advertisement

AT Commands Summary
AT Command
&D
+MCWAKE
+MGGIND
+CFUN
+ICF
S97
+MRST
+MIOC
+MIOD
+MMAD
+MPCMC
Audio
Basic Audio Setup Commands
+CRSL
+CLVL
+CMUT
S94
S96
Advanced Audio Setup Commands
+MAPATH
+MAVOL
1-20
Table 1-1: AT Commands (Cont.)
Description
This command determines how the G24-L responds when the DTR
(Data Terminal Ready) status is changed from ON to OFF during the
online data state.
This command displays reports on the status of the GPRS/GSM
coverage.
This command configures the service indicator on pin 49 of the 70
pin connector to be GPRS or GSM.
This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
This command determines the local serial port start/stop
(asynchronous) character framing used by the DCE when accepting
DTE commands and transmitting information text and result codes.
This command indicates whether an antenna is physically connected
to the G24-L RF connector.
This command enables customer software to perform a hard reset to
the G24-L unit.
This command defines the G24-L 8 GPIO pins data value.
This command defines the G24-L 8 GPIO pins configuration.
This command reads and monitors digital value from a specified
ADC.
This command defines whether the PCM clock is generated
continuously or not, when module is in digital audio mode.
This command handles the selection of the incoming call ringer and
alert tone (SMS) sound level on the alert speaker of the G24-L.
This command sets the volume of the internal loudspeaker (which
also affects the key feedback tone) of the G24-L.
This command mutes/unmutes the currently active microphone path
by overriding the current mute state.
This S-parameter represents the Boolean status, On/Off, of the
sidetone feature.
This S-parameter represents the Boolean status, On/Off, of the echo
cancelling feature in the handsfree.
This command sets/requests the active input accessory, and the
output accessory for each feature.
This command determines a volume setting for a particular feature
in a particular accessory.
G24-L AT Commands Reference Manual
Page
Page 3-138
Page 3-139
Page 3-140
Page 3-141
Page 3-142
Page 3-143
Page 3-143
Page 3-144
Page 3-147
Page 3-149
Page 3-153
Page 3-158
Page 3-159
Page 3-160
Page 3-161
Page 3-162
Page 3-163
Page 3-166
April 15, 2008

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G24-lc

Table of Contents