Miod Parameters; Keypad Gpios - Motorola AT Commands G24-L Developer's Manual

Hardware Information
The following table shows the +MIOD parameters.
<Parameter>
<pin selection>
<mode>
<mode vector>
<data vector>
The following table shows the keypad GPIOs.
3-148
Table 3-96: +MIOD Parameters
Selected pins for the action invoked. This is a binary vector in which each bit points to
pin number. Vector size is 8.
0 Not selected
1 Selected pin (default)
GPIO pin operation mode.
0 Output (level only)
1 Input (level mode)
This is a binary vector in which each bit shows the operation mode of pin. Data vector
size is 8.
0 Output (level only)
1 Input (level mode)
The default value:
On Power Up - as previously saved in FLEX bytes.
Before set command first used - 1. (This means that all lines are configured as Input
before set command first used).
This is a binary vector in which each bit shows the physical value of pin. Data vector
size is 8.
0 Physical low signal.
1 Physical high signal (default).
The default value:
On Power Up - as previously saved in FLEX bytes.
Before set command first used with <Data vector> and <Mode>=0, or after +MIOD
without <Data vector> and before +MIOD command used - 1.
Table 3-97: Keypad GPIOs
GPIO
connector,
Name
GPIO1
GPIO2
GPIO3
GPIO4
GPIO5
GPIO6
GPIO7
GPIO8
G24-L AT Commands Reference Manual
Description
70 PIN
GPIO
Number
PIN#
28 1
30 2
32 3
34 4
36 5
38 6
40 7
42 8
April 15, 2008