Motorola AT Commands G24-L Developer's Manual page 191

This command is a non-basic command, which means that the G24-L module rejects the
command with an appropriate error message when the SIM is not present and/or the phone is in
lock state.
Command Type
Set
Read
Test
April 15, 2008
Syntax Response/Action
+MFS=<freq> OK
[,<mode>]
or:
+CME ERROR: <err>
+MFS? +MFS: <freq>,<mode>
OK
or:
+CME ERROR: <err>
+MFS=? +MFS: (List of
supported <freq>,(List
of supported <mode>s)
OK
or:
+CME ERROR: <err>
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
This command enables you to change
and store in Flex the new values of
Frequency of Search <freq> and
Search mode <mode>.
If only the <freq> value is given, then
the Set command is interpreted as
follows:
• Store new <freq> value. The
<mode> value remains unchanged.
If <freq> and <mode> values are
given, then the Set command is
interpreted as follows:
• Store new <freq> and <mode>
values.
Otherwise, an error message is sent to
the DTE.
Note: If the phone is not registered,
then a set operation of Search
mode to Manual is refused and
ERROR is sent to the DTE.
The Read command returns the current
settings for values of <freq> and
<mode>.
The Test command returns the possible
<freq> and <mode> values.
3-127