Mipsets, Set Size For Automatic Push; Mipsets Parameters - Motorola AT Commands G24-L Developer's Manual

+MIPSETS, Set Size for Automatic Push

This command causes the G24-L to set a watermark in the accumulating buffer. When the
watermark is reached, data is pushed from the accumulating buffer into the protocol stack.
Data chunks between the terminal and the G24-L are limited to be smaller than 80 characters (160
characters in coded form). In order to reduce the overhead of sending small amounts of data over
the air, the G24-L uses an accumulating buffer. The terminal can specify a watermark within the
accumulating buffer size limits to indicate how much data should be accumulated. When the data
in the accumulating buffer exceeds the watermark, only data equal to the watermark is sent. Data
remaining in the buffer is sent with the next packet.
Note:
Command
Type
Set
Read
Test
The following table shows the +MIPSETS parameters.
Example
AT+MIPSETS=1,340
(socket should be activated by the +mipopen command
+MIPSETS: 0
OK
AT+MIPSETS=1,200
(socket should be activated by the +mipopen command)
+MIPSETS: 0
OK
AT+MIPSETS=2,400
+MIPSETS: 0
OK
AT+MIPSETS=?
April 15, 2008
If there is data in the accumulating buffer, the +MIPSETS command will be rejected.
Syntax
+MIPSETS= <Socket ID>,<Size>
+MIPSETS?
+MIPSETS=?
Table 3-199: +MIPSETS Parameters
<Parameter>
Size
Extended err
//Asks the G24-L to accumulate 340 bytes on socket 1 prior to sending
//Asks the G24-L to accumulate 200 bytes on socket 1 prior to sending
//Asks the G24-L to accumulate 400 bytes on socket 2 prior to sending
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
OK
or:
ERROR
+MIPSETS: <err>
+MIPSETS: [<SocketID>,<Current Size Settings>]
For all ACTIVE sockets.
+MIPSETS: (1-4),(list of supported <size>s)
Description
Size of the buffer
< size ≤ 1372
1
The default value is 1372.
3 Operation not allowed
Response/Action
3-283