Advanced Audio Setup Commands; Mapath, Audio Path; S96 Parameters - Motorola AT Commands G24-L Developer's Manual

The following table shows the S96 parameters.
<Parameter>
<n>
Example
ATS96=1
OK
ATS96=4
+CME ERROR: <err>
ATS96?
001
OK

Advanced Audio Setup Commands

This group of commands enables accessory devices to control certain audio aspects within the
system.

+MAPATH, Audio Path

This command sets/requests the active input accessory, and the output accessory for each feature.
For example, you can choose the headset mic to be active, the voice and keypad feedbacks to go
to the speaker, and the alerts and rings to go to the alert speaker. On power up, the default path,
mic, speaker and alert speaker are restored.
Note:
April 15, 2008
Table 3-107: S96 Parameters
0 Disable echo canceling. Disable noise suppression
1 Enable echo canceling. Enable noise suppression
//Enable echo canceling
//Echo canceling enabled
+MAPATH cannot be used to set digital audio, but only to read it. In order to set the digital
audio path, use +MADIGITAL. For more information, refer to section
Analog/Digital Audio Switching" on page
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
3-170.
"+MADIGITAL,
3-163