Mipopen Parameters - Motorola AT Commands G24-L Developer's Manual

GPRS
Command Type
Read
Test
Example
+MIPOPEN: 1 2 3 4
+MIPOPEN: 1 3 4
The following table shows the +MIPOPEN parameters.
<Parameter>
Socket ID
Source Port
Destination
Address
Destination
Port
Protocol
State
Note:
3-278
Syntax
AT+MIPOPEN?
AT+MIPOPEN=?
//All sockets closed
//Socket 2 opened
Table 3-196: +MIPOPEN Parameters
A unique number that identifies a connection (provided by the terminal application).
0 Invalid socket number
1,2,3,4 Valid socket number
Port of source site.
Port range: 1-65535 (decimal digits)
IP: IP of the destination site in the format "AAA.BBB.CCC.DDD". The range of each
octant is 0-255. The value can be written in 1, 2, or 3 digits.
Host name: Host-name of destination site. The host-name do not validate, except the
maximum length (255 characters), the host-name convention should meet the rules as
describe in RFC-1035 section: 2.3. Conventions.
Port of destination site.
Port range: 1-65535 (decimal digits).
Type of protocol stack.
0 TCP
1 UDP
State of socket or error indication.
0 Inactive
1 Active
Motorola does not recommend using port numbers below 1024. These numbers are
defined to be reserved for operating systems.
G24-L AT Commands Reference Manual
Response/Action
+MIPOPEN:[<SocketID>]
for each socket that can be opened
or:
+MIPOPEN 0
if there are no free sockets.
+MIPOPEN: (list of supported
<socket ID>s),(list of supported
<source port>s),(list of
supported<"Destination IP">s),
(list of <destination port>s),(list of
supported <protocol>s)
Description
Remarks
The Read command
returns the numbers of
the sockets that can be
opened.
April 15, 2008