Mipclose, Close A Socket; Mipclose Parameters - Motorola AT Commands G24-L Developer's Manual

GPRS

+MIPCLOSE, Close a Socket

This command causes the G24-L to free the socket accumulating buffer and to close the socket.
Note:
Command
Type
Set
Read
Test
The following table shows the +MIPCLOSE parameters.
<Socket_ID>
<number_of_acknowledged_bytes >
Example
AT+MIPCLOSE=1
OK
AT+MIPCLOSE=2
ERROR
AT+MIPCLOSE?
+MIPCLOSE: 1 2
AT+MIPCLOSE?
+MIPCLOSE: 0
3-282
All data stored in the accumulating buffer will be lost. Refer to
Automatic Push" on page 3-283
page 3-285.
Syntax
+MIPCLOSE = <Socket ID>
+MIPCLOSE?
+MIPCLOSE=?
Table 3-198: +MIPCLOSE Parameters
<Parameter>
//The terminal closes the opened socket
//The terminal closes the socket that wasn't opened
//Sockets 1 and 2 are opened
//No opened sockets
G24-L AT Commands Reference Manual
and "+MIPPUSH, Push Data into Protocol Stack" on
Response/Action
OK
+MIPCLOSE: <Socket ID>[,<
number_of_acknowledged_bytes >]
or:
ERROR
+MIPCLOSE 1234
+MIPCLOSE: [<socket ID>] - for all ACTIVE
sockets.
+MIPCLOSE: (1-4)
OK
Description
A unique number that identifies a connection.
Valid socket numbers - 1, 2, 3, 4
Total number of bytes that were acknowledged.
"+MIPSETS, Set Size for
April 15, 2008