Figure 43 - License Key Data Entry - Motorola PTP 58500 User Manual

8 Web Page Reference
CAUTION: The factory default configuration is set to Region 26. Region 26 allows the 500
Series bridge a maximum transmit power of 27 dBm. If the local regulatory regime limits the
maximum transmit power (EIRP) to less than 27 dBm you should obtain a new license key
containing the correct region code from your local distributor or direct from Motorola.
Alternatively in the short term, you should reduce the maximum transmit power by following
the procedures in Section 8.3.4.1 'Manually Configuring The Wireless Units'.
8.3.4.1 Manually Configuring The Wireless Units
If the installer / system administrator wishes, they may modify the default installation
configuration. If only the IP addresses (network configuration) are incorrect it is recommended
that the values are changed via the configuration menu (Section 8.3.1.2 "LAN Configuration
Page"). If any other parameters require modification then it is recommended that the system
administrator use the Installation Wizard.
A detailed description of the Installation Wizard follows:
The 500 Series bridge operational software requires a license key to enable the wireless
bridging capability and programs region code specific parameters in to the unit.

Figure 43 - License Key Data Entry

105