Hardware Information
+MGGIND, GSM/GPRS Service Indicator
This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note:
Set
Read
Test
The following table shows the +MGGIND parameters.
<Parameter>
<state>
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
3-140
IO line (pin 49) outcome depends on +MCWAKE configuration.
Command Type
AT+MGGIND=<state>
AT+ MGGIND ?
AT+ MGGIND =?
Table 3-91: +MGGIND Parameters
0
GPRS registration indicator.
1
GSM registration indicator.
G24-L AT Commands Reference Manual
Syntax
OK
or:
+CME ERROR: <err>
+MGGIND: <state>
OK
or:
+CME ERROR: <err>
+MGGIND: (list of supported
<state>s)
OK
Description
Response/Action
April 15, 2008