Clir Parameters - Motorola AT Commands G24-L Developer's Manual

Call Control
Note:
Command
Type
Set
Read
Test
The following table shows the +CLIR parameters.
<Parameter>
<n>
<m>
Example
AT+CLIR=?
+CLIR: (0,1,2)
OK
AT+CLIR?
+CLIR: 1,4
AT+CLIR=2
OK
atd054565195;
OK
(... calling ...)
(... a G24-L that has 054565195 SIM and is CLIP enabled will receive the following on the terminal:
RING
+CLIP: "",128,,128,"",1
3-30
When a service is in state A, and the terminal wants to enable the CLI presentation (turn
CLIR off) for a single call, it can do so using the ATD command. This does not change
the Temporary mode state. This can also be done when the service is in state B and the
terminal wants to disable the CLI presentation (turn CLIR on) for a single call.
Syntax Response/Action
+CLIR=<n> OK
+CLIR? +CLIR:<n>,<m>
OK
+CLIR=? +CLIR: (list of supported
<n>s)
Table 3-13: +CLIR Parameters
Adjustment for outgoing calls
0 - Presentation indicator is used according to the subscription of the CLIR service
1 - CLIR invocation
2 - CLIR suppression
The default is 2.
Subscriber CLIR service status in the network
0 - CLIR not provisioned
1 - CLIR provisioned in permanent mode
2 - Unknown (for example, no network and so on)
3 - CLIR Temporary mode presentation restricted (can be the default)
4 - CLIR Temporary mode presentation allowed (can be the default)
//MO voice call
G24-L AT Commands Reference Manual
Remarks
The Set command instructs the G24-L to
enable/disable CLI restriction for all MO
calls.
The Read command returns the current
setting of CLIR on the network <m> and
on the G24-L <n>.
The Test command returns <n> values
supported by the G24-L.
Description
April 15, 2008