E, Command Echo; Qn Parameters; En Parameters - Motorola AT Commands G24-L Developer's Manual

Modem Configuration and Profile
The following table shows the Qn parameters.
Example
ATQ0
OK
ATQ?
Q: 0
OK
ATQ4
ERROR
ATQ1
ATQ4

E, Command Echo

This command defines whether input characters are echoed to output. If so, these characters are
echoed at the same rate, parity and format at which they were received.
Command Type
Set
Read
Test
The following table shows the E parameters.
<Parameter>
<value>
3-192
Table 3-128: Qn Parameters
<Parameter>
<value> 0 Transmit result codes.
1 Suppress result codes.
The default value is 0.
//No response because result codes are suppressed.
//No response because result codes are suppressed.
Syntax Response/Action
ATE<value> OK
or:
+CME ERROR: <err>
ATE? <current value>
Table 3-129: En Parameters
0 Does not echo characters
1 Echoes characters
The default value is 0.
G24-L AT Commands Reference Manual
Description
Remarks
The Set command sets whether or not
to echo characters.
The Read command reads the current
setting for command echo.
The Test command for E is not defined
by ITU, and therefore is not supported
by the G24-L. The G24-L returns an
error.
Description
April 15, 2008