S, Bit Map Registers - Motorola AT Commands G24-L Developer's Manual

Modem Configuration and Profile

S, Bit Map Registers

This command reads/writes values of the S-registers. The G24-L supports this command for
various S values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command Type
Set
Read
Test
3-194
Syntax Response/Action
ATSn=<value> OK
or:
+CME ERROR: <err>
ATSn? <current value of
S-register n>
or:
+CME ERROR: <err>
G24-L AT Commands Reference Manual
Remarks
The Set command is allowed for
read/write S-registers, and not allowed
for read-only S-registers.
The Test command for Sn is not
defined by ITU, and therefore is not
supported by the G24-L. The G24-L
returns an error.
April 15, 2008