Clcc, List Current Calls - Motorola AT Commands G24-L Developer's Manual

Call Control

+CLCC, List Current Calls

This command displays a list of all current G24-L calls and their statuses, and also
enables/disables the unsolicited indication of the call list. (If no calls are received, no information
response is sent to the terminal).
If the command succeeds but no calls are available, no information response is sent to the
terminal.
The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 on hold).
Command
Type
Set
Execute
Read
Test
3-40
Syntax Response/Action
AT+CLCC=<state> OK
or:
+CME ERROR: <err>
AT+CLCC +CLCC: <idx>,<dir>,<call
state>, <mode>,
<mpty>[,<number>,<type>,
<alpha>]
[<CR><LF>+ CLCC:
<idx>,<dir>,<call state>,
<mode>,<mpty>[,<number>
,<type>,<alpha>]
[...]]
OK
AT+CLCC? +CLCC: <state>
OK
or:
+CME ERROR <err>
AT+CLCC=? +CLCC: (List of supported
<state>s)
OK
or:
+CME ERROR <err>
G24-L AT Commands Reference Manual
Remarks
The Set command enables/disables
unsolicited indications.
The Execute command enables
the receiving of data about
current calls.
The Read command returns the call
status.
April 15, 2008