Motorola AT Commands G24-L Developer's Manual page 354

GPRS
parameters before socket activation or when the socket is in active state. Configuration values
will be stored in G24-L until power circle.
Command Type
Set
Read
Test
The following table shows the +MIPCONF parameters.
< socket >
< retr_num >
< min_TO >
<max_TO>
3-290
Syntax
AT+MIPCONF=<
socket>[,[<retr_n
um>],[<min_TO>
],[<max_TO>],[<
max_close_delay>
][,<is_nack_ind_r
eq>]]
+MIPCONF?
+MIPCONF=?
Table 3-206: +MIPCONF Parameters
Parameter
Number of configured TCP socket (1 to 4)
Number of retransmissions (1 to 5)
Bottom limit to retransmit timeout ( 100 ms to 1 sec.)
Upper limit to retransmit timeout (1 sec. to 60 sec.)
G24-L AT Commands Reference Manual
Response/Action
OK
or:
+CME ERROR: <err>
+MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
+MIPCONF:
(1-4),(1-5),(1-10),(10-600),(1-75),(0-2)
Description
Remarks
The Set updates TCP
stack configuration
parameters.
The read command
returns current
settings of TCP stack
parameters.
The Test command
returns the possible
parameters values.
Time values can be
inserted with
resolution of 100
milliseconds.
April 15, 2008