Motorola AT Commands G24-L Developer's Manual page 216

Hardware Information
<Parameter>
<Report_interv
0 - 255 Time interval between two averages reports (seconds).
al>
<Average>
Average calculation result.
Example
AT+MMAD =1
+MMAD:1,175
OK
AT+MMAD=2,1,15
OK
+MMAD: 2, 10
+MMAD: 2, 12
AT+MMAD= 3, 2,1,25,100
OK
+MMAD: 3,102
:
minutes, rate=5.
duration=5
AT+MMAD =1,3,5, , ,16,5,30
OK
+MMAD:1,175
+MMAD:1,140
.....
+MMAD:1,160
AT+MMAD =1,0,5, , ,16,5,0
duration=5 min
OK
AT+MMAD=1
OK
3-152
Table 3-98: +MMAD Parameters (Cont.)
Description
// Read A2D1 values with analog input of 1.75V.
// Read A2D2 converted value every 15 seconds and send
// unsolicited report to the DTE.
// Unsolicited Report after 15 seconds.
// Unsolicited Report after 30 seconds.
// Read A2D3 converted value every 1 second and send
// unsolicited report if the converted value is out of boundaries.
// Unsolicited report of value out of boundaries.
// Activate Average calcluation periodically every 30 sec, during 5
// report originated by G24
// Converter num=1, report=3, rate=5*100ms, low,high, N_samples,
//First report
//Second report
//Last Avr report
// Activate Average calcluation during 5 minutes, rate=5.
// Converter num=1, report=0, rate=5*100ms, low,high, 16,
//Only on explicit "AT+MMAD=<Converter_number>" command
G24-L AT Commands Reference Manual
Range/Remark
0 - Default value.
April 15, 2008