Table of Contents
Advertisement
Redirect Policy Commands
Redirect policies can contain multiple destinations. Each destination is assigned an initial or base
Description
priority which describes its relative importance within the policy. If more than one destination is
specified, the destination with the highest effective priority value is selected.
100
Default
priority — The priority, expressed as a decimal integer, used to weigh the destination's relative
Parameters
snmp-test
Syntax
snmp-test test-name
config>filter>redirect-policy>destination
Context
This command enables the context to configure SNMP test parameters.
Description
none
Default
test-name — specifies the name of the SNMP test. Allowed values are any string up to 32 characters
Parameters
oid
Syntax
oid oid-string community community-string
config>filter>redirect-policy>destination>snmp-test
Context
This command specifies the OID of the object to be fetched from the destination.
Description
none
Default
oid-string — Specifies the object identifier (OID) in the OID field.
Parameters
community community-string — The SNMP v2 community string or the SNMP v3 context name
used to conduct this SNMP test.
return-value
return-value return-value type return-type [disable | lower-priority priority | raise-priority
Syntax
priority]
config>filter>redirect-policy>destination>snmp-test
Context
This command specifies the criterion to adjust the priority based on the test result. Multiple criteria
Description
can be specified with the condition that they are not conflicting or overlap. If the returned value is
Page 490
importance within the policy.
1 — 255
Values
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
