Table of Contents
Advertisement
Global Filter Commands
filter-id — The MAC filter policy ID number.
Parameters
create — Keyword required when first creating the configuration context. Once the context is
filter-name — A string of up to 64 characters uniquely identifying this filter policy.
redirect-policy
[no] redirect-policy redirect-policy-name
Syntax
config>filter
Context
This command configures redirect policies.
Description
The no form of the command removes the redirect policy from the filter configuration only if the
policy is not referenced in an IP filter and the IP filter is not in use (applied to a service or network
interface).
none
Default
redirect-policy-name — Specifies the redirect policy name. Allowed values are any string up to 32
Parameters
log
log log-id [create]
Syntax
no log
config>filter
Context
This command enables the context to create a filter log policy.
Description
The no form of the command deletes the filter log ID. The log cannot be deleted if there are filter
entries configured to write to the log. All filter entry logging associations need to be removed before
the log can be deleted.
Filter log 101 — Filter log 101 is the default log and is automatically created by the system. Filter
Special Cases
log 101 is always a memory filter log and cannot be changed to a Syslog filter log. The log size
defaults to 1000 entries. The number of entries and wrap-around behavior can be edited.
Default
log 101
log-id — The filter log ID destination expressed as a decimal integer.
Parameters
Page 444
1 — 65535
Values
created, one can navigate into the context without the create keyword.
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes. There is
no limit to the number of redirect policies that can be configured.
101 — 199
Values
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
