Table of Contents
Advertisement
Router L2TP Commands
local-address
Syntax
local-address ip-address
no local-address
config>router>l2tp>group>tunnel
Context
This command configures the local address.
Description
ip-address — Specifies the IP address used during L2TP authentication.
Parameters
local-name
Syntax
local-name host-name
no local-name
config>router>l2tp>group
Context
config>router>l2tp>group>tunnel
This command creates the local host name used by this system for the tunnels in this L2TP group
Description
during the authentication phase of tunnel establishment. It can be used to distinguish tunnels.
The no form of the command removes thename from the configuration.
local-name
Default
host-name — Specifies the host name, up to 64 characters in length, that the router will use to identify
Parameters
max-retries-estab
Syntax
max-retries-estab max-retries
no max-retries-estab
config>router>l2tp>group
Context
config>router>l2tp>group>tunnel
This command configures the number of retries allowed for this L2TP tunnel while it is established,
Description
before its control connection goes down.
The no form of the command removes the value from the configuration.
no max-retries-estab
Default
max-retries — Specifies the maximum number of retries for an established tunnel.
Parameters
Page 126
itself during L2TP authentication.
no local-name
Default
no max-retries-estab
Default
2 — 7
Values
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
