Alcatel-Lucent 7450 ESS Series Configuration Manual page 472

Match List Configuration Commands
Please see general description related to match-list usage in filter policies.
ipv6-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
Parameters
apply-path
Syntax apply-path
no apply-path
config>filter>match-list>ip-pfx-list
Context
config>filter>match-list>ipv6-pfx-list
This command enables context to configure auto-generation of address prefixes for IPv4 or IPv6
Description
address prefix match lists. The context the command is executed governs whether IPv4 or IPv6
prefixes will be auto-generated.
The no form of this command removes all auto-generation configuration under the apply-path
context.
no apply path
Default
bgp-peers
Syntax bgp-peers index group reg-exp neighbor reg-exp
no bgp-peers index
config>filter>match-list>ip-pfx-list>apply-path
Context
config>filter>match-list>ipv6-pfx-list>apply-path
This command configures auto-generation of IPv4 or IPv6 address prefixes (as required by the
Description
context the command is executed within) based on the base router BGP instance configuration.
The no form of this command removes the bgp-peers configuration for auto-generation of address
prefixes for the specified index value.
No embedded filter policies are included in a filter policy.
Default
index — An integer from 1 to 255 enumerating bgp-peers auto-generation configuration within this
Parameters
Page 472
characters are used, the string must be enclosed within double quotes.
group:
Configures a match against base router BGP instance group configuration.
Regex wildcard match (.*) can be used to match against any group.
neighbor:
Configures a match against base router BGP instance neighbor configuration.
Regex wildcard match (.*) can be used to match against any neighbor.
list.
7450 ESS OS Router Configuration Guide