Table of Contents
Advertisement
Router L2TP Commands
configure>service>vprn>l2tp>tunnel-selection-blacklist
This command configures time for which an entity (peer or a tunnel) are kept in the blacklist.
Description
5 minutes
Default
minutes — Specifies the maximum time a tunnel or peer may remain in the blacklist
Parameters
timeout-action
Syntax
timeout-action action
no timeout-action
configure>router>l2tp>tunnel-selection-blacklist
Context
configure>service>vprn>l2tp>tunnel-selection-blacklist
This command defines an action that will be executed on the entity (peer/tunnel) in the blacklist once
Description
the entity becomes eligible for selection again.
remove-from-blacklist
Default
action — Specifies the Action to be taken when a tunnel or peer has been in the blacklist for the
Parameters
Page 136
1..60
Values
max-period of time.
remove-from-blacklist — The peer or tunnel in the blacklist will be removed
Values
completely from the blacklist and made eligible for the selection process once the
max-time expires. In this mode of operation, multiple new sessions can be mapped
into the same, newly released tunnel from the blacklist. The first such session will
try to setup the tunnel, while the other will be buffered until the tunnel
establishment process is completed. In case that the tunnel remains unavailable, it
will be placed in the blacklist again. Consequently all new sessions will have be
re-negotiated over an alternate tunnel.
try-one-session — Once the max-time expired, the peer or tunnel in the blacklist is
made available for selection only to a single new session request. Only upon
successful tunnel establishment will the incoming new sessions be eligible to be
mapped into this tunnel. This behavior will avoid session establishment delays in
case that the tunnel just removed from the blacklist is still unavailable.
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
