Table of Contents
Advertisement
multiplier
Syntax
multiplier multiplier
no multiplier
config>router>bfd>bfd-template
Context
This command specifies the detect multiplier used for a BFD session. If a BFD control packet is not
Description
received for a period of multiplier x receive-interval, then the session is declared down.
3
Default
multiplier — Specifies the multiplier.
Parameters
type
[no] type cpm-np
Syntax
config>router>bfd>bfd-template
Context
This command selects the CPM network processor as the local termination point for the BFD session.
Description
This is enabled by default.
type cpm-np
Default
triggered-policy
Syntax
triggered-policy
no triggered-policy
config>router
Context
This command triggers route policy re-evaluation.
Description
By default, when a change is made to a policy in the config router policy options context and then
committed, the change is effective immediately. There may be circumstances when the changes
should or must be delayed; for example, if a policy change is implemented that would affect every
BGP peer on a router, the consequences could be dramatic. It would be more effective to control
changes on a peer-by-peer basis.
If the triggered-policy command is enabled, and a given peer is established, and you want the peer to
remain up, in order for a change to a route policy to take effect, a clear command with the soft or soft
inbound option must be used; for example, clear router bgp neighbor x.x.x.x soft. This keeps the
peer up, and the change made to a route policy is applied only to that peer or group of peers.
7450 ESS OS Router Configuration Guide
100
Default
3 — 20, integers
Values
3
Default
IP Router Configuration
Page 109
Advertisement
Table of Contents
