Router L2TP Commands
destruct-timeout
Syntax
destruct-timeout destruct-timeout
no destruct-timeout
config>router>l2tp>group
Context
config>router>l2tp>group>tunnel
This command configures the period of time that the data of a disconnected tunnel will persist before
Description
being removed.
The no form of the command removes the value from the configuration.
no destruct-timeout
Default
destruct-timeout — [Specifies the automatic removal of dynamic L2TP sessions, in seconds, that are
Parameters
hello-interval
Syntax
hello-interval hello-interval
no hello-interval
config>router>l2tp>group
Context
This command configures the time interval between two consecutive tunnel Hello messages. The
Description
Hello message is an L2TP control message sent by either peer of a LAC-LNS control connection.
This control message is used as a keepalive for the tunnel.
The no form of the command removes the interval from the configuration.
60
Default
hello-interval — Specifies the time interval, in seconds, between two consecutive tunnel Hello
Parameters
idle-timeout
Syntax
idle-timeout idle-timeout
Page 124
no challenge
Default
always
Values
no longer active.
no destruct-timeout
Default
60 — 86400
Values
messages.
no hello-interval
Default
60 — 3600
Values
7450 ESS OS Router Configuration Guide