Alcatel-Lucent 7450 ESS Series Configuration Manual page 460

IP (v4/v6) Filter Entry Commands
match
match [next-header next-header]
Syntax
no match
config>filter>ipv6-filter>entry
Context
This command enables the context to enter match criteria for the filter entry. When the match criteria
Description
have been satisfied the action associated with the match criteria is executed.
If more than one match criteria (within one match statement) are configured then all criteria must be
satisfied (AND function) before the action associated with the match is executed.
A match context may consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
The no form of the command removes the match criteria for the entry-id.
next-header — Specifies the IPv6 next header to match. Note that this parameter is analogous to the
Parameters
dscp
Syntax dscp dscp-name
no dscp
config>filter>ip-filter>entry>match
Context
config>filter>ipv6-filter>entry>match
This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match
Description
criterion.
The no form of the command removes the DSCP match criterion.
Default
no dscp
dscp-name — Configure a dscp name that has been previously mapped to a value using the dscp-
Parameters
dst-ip
dst-ip {ipv-address[/mask]} [netmask
Syntax
dst-ip {ipv6-address/prefix-length | ipv6-address netmask | ipv6-prefix-list prefix-list-name}
no dst-ip
config>filter>ip-filter>entry>match
Context
config>filter>ipv6-filter>entry>match
Page 460
protocol parameter used in IP-Filter match criteria.
name command. The DiffServ code point may only be specified by its name.
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15,
Values
cs2, cp17, af21, cp19, af22, cp21, af23, cp23
|
ip-prefix-list prefix-list-name]
7450 ESS OS Router Configuration Guide