Table of Contents
Advertisement
Router Interface Commands
proxy-arp-policy
[no] proxy-arp-policy policy-name [policy-name...(up to 5 max)]
Syntax
config>router>interface
Context
This command enables and configure proxy ARP on the interface and specifies an existing policy-
Description
statement to analyze match and action criteria that controls the flow of routing information to and
from a given protocol, set of protocols, or a particular neighbor. The policy-name is configured in the
config>router>policy-options context.
Use proxy ARP so the router responds to ARP requests on behalf of another device. Static ARP is
used when a 7450 ESS needs to know about a device on an interface that cannot or does not respond
to ARP requests. Thus, the 7450 ESS OS configuration can state that if it has a packet that has a
certain IP address to send it to the corresponding ARP address.
no proxy-arp-policy
Default
policy-name — The export route policy name. Allowed values are any string up to 32 characters long
Parameters
ptp-hw-assist
[no] ptp-hw-assist
Syntax
config>router>interface
Context
This command configures the 1588 port based timestamping assist function for the interface. Various
Description
checks are performed to ensure that this feature can be enabled. If a check fails:
no ptp-hw-assist
Default
Page 150
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. The specified policy
name(s) must already be defined.
• The command is blocked/rejected with an appropriate error message.
• If the SAP configuration of the interface is removed, the ptp-hw-assist configuration will be
removed.
• If the IPv4 address configuration of the interface is removed, the ptp-hw-assist configuration will
be removed.
ccag
id
path-id
cc-type
lag-id
lag-id
lag
id
7450 ESS OS Router Configuration Guide
keyword
1 — 8
a, b
.sap-net, .net-sap
keyword
1 — 200
Advertisement
Table of Contents
