Table of Contents
Advertisement
address is advertised via IGPs and LDP protocols to allow the resolution of BGP routes advertised
with this address by the primary multihoming router.
The no form of the command disables this setting.
no mh-secondary-interface
Default
hold-time
Syntax
hold-time holdover-time
no hold-time
config>router>mh-secondary-interface
Context
The optional hold-time parameter is only applicable for the secondary context and specifies how long
Description
label information leraned about the secondary anycast address should be kept after that peer is
declared down. This timer should be set to a value large enough for the remainder of the network to
detect the failure and complete the reconvergence process.
The no form of the command resets the hold-time back to the default value.
no hold-time
Default
holdover-time — Specifies the number of seconds the router should hold label information learned
Parameters
7450 ESS OS Router Configuration Guide
from the alternate router in its secondary label table. This is to allow the reset of the network to
reconverge after a router failure before the anycast based label assignments are flushed from the
forwarding plane.
0-65535
Values
90
Default
IP Router Configuration
Page 161
Advertisement
Table of Contents
