Table of Contents
Advertisement
Show Commands
policy-edits
Syntax
policy-edits
show>router
Context
This command displays edited policy information.
Description
route-table
route-table [family] [ip-prefix[/prefix-length] [longer|exact|protocol protocol-name] [all]]
Syntax
[next-hop-type type][qos][alternative]
route-table [family] summary
route-table tunnel-endpoints [ip-prefix[/prefix-length]] [longer|exact] [detail]
show>router
Context
This command displays the active routes in the routing table.
Description
If no command line arguments are specified, all routes are displayed, sorted by prefix.
family — Specify the type of routing information to be distributed by this peer group.
Parameters
ip-prefix[/prefix-length] — Displays routes only matching the specified ip-address and length.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
exact — Displays the exact route matching the ip-prefix/mask masks.
protocol protocol-name — Displays routes learned from the specified protocol.
summary — Displays a route table summary information.
tunnel-endpoints — Specifies to include tunnel endpoint information.
next-hop-type tunneled — Displays only the tunneled next-hops. For each route entry, the tunnel
Standard Route Table Output — The following table describes the standard output fields for the
Output
route table.
Dest Address
Next Hop
Page 214
ipv4 — Displays only those BGP peers that have the IPv4 family enabled and not
Values
those capable of exchanging IP-VPN routes.
mcast-ipv4 — Displays the BGP peers that are IPv4 multicast capable.
ipv4-prefix:
Values
ipv4-prefix-length:
local, sub-mgmt, managed, static, ospf, ospf3, isis, rip, aggregate, bgp, bgp-vpn
Values
owner and tunnel ID is shown.
Label
The route destination address and mask.
The next hop IP address for the route destination.
a.b.c.d (host bits must be set to 0)
0 — 32
Description
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
