Table of Contents
Advertisement
no shutdown
Default
summary
Syntax
summary
config>filter>log
Context
This command enables the context to configure log summarization. These settings will only be taken
Description
into account when syslog is the log destination. Note that summary settings will only be taken into
account in case the log destination is syslog.
none
Parameters
summary-crit
Syntax
summary-crit dst-addr
summary-crit src-addr
no summary-crit
config>filter>log>summary
Context
This command defines the the key of the index of the minitable. If key information is changed while
Description
summary is in no shutdown, the filter summary minitable is flushed and recreated with different key
information. Log packets received during the reconfiguration time will be handled as if summary was
not active.
The no form of the command reverts to the default parameter.
dst-addr
Default
dst-addr — Specifies that received log packets are summarized based on the destination IP, IPv6, or
Parameters
src-addr — Specifies that received log packets are summarized based on the source IP, IPv6 or MAC
wrap-around
[no] wrap-around
Syntax
config>filter>log
Context
This command configures a memory filter log to log until full or to store the most recent log entries
Description
(circular buffer).
Specifying wrap-around configures the memory filter log to store the most recent filter log entries
(circular buffer). When the log is full, the oldest filter log entries are overwritten with new entries.
7450 ESS OS Router Configuration Guide
MAC address.
address.
Filter Policies
Page 447
Advertisement
Table of Contents
