Table of Contents
Advertisement
Router Global Commands
single-sfm-overload
single-sfm-overload [holdoff-time holdoff-time]
Syntax
no single-sfm-overload
config>router
Context
This command, if enabled, will cause the OSPF for the service to enter an overload state when the
Description
node only has a single SFM functioning.
The no form of this command causes the overload state to be cleared.
no single-sfm-overload
Default
holdoff-time — This parameter specifies the delay between the detection of a single SFM and
Parameters
static-route
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
Syntax
[metric metric] [tag tag] [community comm-id] [enable | disable] next-hop ip-int-name |
ip-address [mcast-family] [bfd-enable |{cpe-check cpe-ip-address [interval seconds]
[drop-count count] [log]} {prefix-list prefix-list-name [all | none]} |{fc fc-name [priority
{low | high}]} ] [ldp-sync]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [community comm-id] [enable | disable] indirect ip-address [ldp |
rsvp-te [disallow-igp]] [cpe-check cpe-ip-address [interval seconds] [drop-count count]
[log]] {prefix-list prefix-list-name [all | none]} |{fc fc-name [priority {low | high}]}
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [community comm-id] [enable | disable] black-hole [mcast-
family] {prefix-list prefix-list-name [all | none]}
config>router
Context
This command creates static route entries for both the network and access routes.
Description
When configuring a static route, either next-hop, indirect or black-hole must be configured.
The no form of the command deletes the static route entry. If a static route needs to be removed when
multiple static routes exist to the same destination, then as many parameters to uniquely identify the
static route must be entered.
If a CPE connectivity check target address is already being used as the target address in a different
static route, then cpe-check parameters must match. If they do not, the new configuration command
will be rejected.
If a static-route command is issued with no cpe-check target but the destination prefix/netmask and
next-hop matches a static route that did have an associated cpe-check, the cpe-check test will be
removed from the associated static route.
Page 110
enacting the overload state.
1— 600 seconds
Values
0 seconds
Default
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
