redirect policy-name — Specifies the redirect policy configured in the config>filter>redirect-policy
interface ip-int-name — The name of the egress IP interface where matching packets will be
sap sap-id — Specifies the physical port identifier portion of the SAP definition. Only Ethernet SAPs
sdp sdp-id:vc-id — specifies SDP defined in the system. now we need to reference to somewhere
http-redirect url — Specifies the HTTP web address that will be sent to the user's browser. Note that
http-redirect is not supported on 7750 SR-1 or 7450 ESS-1 models.
The following displays information that can optionally be added as variables in the portal
URL (http-redirect url):
router service-name service-name — Indicates the service id of the destination for this IP filter
nat — specifyies that matching traffic is to be redirected for NAT performed by Integrated Service
reassemble — Packets matching the filter entry are forwarded to the packet reassembly function in
7450 ESS OS Router Configuration Guide
If the next hop is not available, then a routing lookup will be performed and if a match is found
the packet will be forwarded to the result of that lookup. If no match is found a "ICMP
destination unreachable" message is send back to the origin.
context.
forwarded from. This parameter is only valid for unnumbered point-to-point interfaces. If the
string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
are supported (including q-in-q, BCP, bridged Ethernet in Frame Relay or ATM).Only Ethernet
SAPs are supported (including q-in-q, BCP, and bridged Ethernet in Frame Relay). Refer to
Common CLI Command Descriptions on page 613
descriptions.
where SDP input is defined similarly to SAP reference above.
•
$IP — Customer's IP address
•
$MAC — Customer's MAC address
•
$URL — Original requested URL
•
$SAP — Customer's SAP
•
$SUB — Customer's subscriber identification string"
•
$CID — A string that represents the circuit-id or interface-id of the subscriber host
(hexadecimal format).
•
$RID — A string that represents the remote-id of the subscriber host (hexadecimal
format)
255 characters maximum
Values
entry.
Adapter(s) running NAT application.
the system.
Filter Policies
for SAP CLI command syntax and parameter
Page 457