Alcatel-Lucent 7450 ESS Series Configuration Manual page 468

IP (v4/v6) Filter Entry Commands
netmask — Any mask epressed in dotted quad notation.
prefix-length — The IPv6 mask value for the IPv6 filter entry.
src-port
src-port {lt | gt | eq} src-port-number
Syntax
src-port range src-port-number src-port-number
no src-port
config>filter>ip-filter>entry>match
Context
config>filter>ipv6-filter>entry>match
This command configures a source TCP or UDP port number or port range for an IP filter match
Description
criterion. Note that an entry containing Layer 4 match criteria will not match non-initial (2nd, 3rd,
etc) fragments of a fragmented packet since only the first fragment contains the Layer 4 information.
The no form of the command removes the source port match criterion.
no src-port
Default
lt | gt | eq — Specifies the operator to use relative to src-port-number for specifying the port number
Parameters
src-port-number — The source port number to be used as a match criteria expressed as a decimal
range start end — Specifies an inclusive range of port numbers to be used as a match criteria. The
src-route-option
src-route-option {true|false}
Syntax
no source-route-option
config>filter>ip-filter>entry>match
Context
This command enables source route option match conditions. When enabled, this filter should match
Description
if a (strict or loose) source route option is present/not present at any location within the IP header, as
Page 468
0.0.0.0 — 255.255.255.255
Values
1 — 128
Values
match criteria.
lt specifies all port numbers less than src-port-number match.
gt specifies all port numbers greater than src-port-number match.
eq specifies that src-port-number must be an exact match.
integer.
0 — 65535
Values
source port numbers start-port and end-port are expressed as decimal integers.
0 — 65535
Values
7450 ESS OS Router Configuration Guide