Table of Contents
Advertisement
Router Interface Commands
Router Interface Filter Commands
egress
Syntax
egress
config>router>interface
Context
This command enables access to the context to configure egress network filter policies for the IP
Description
interface. If an egress filter is not defined, no filtering is performed.
ingress
Syntax
ingress
config>router>interface
Context
This command enables access to the context to configure ingress network filter policies for the IP
Description
interface. If an ingress filter is not defined, no filtering is performed.
filter
Syntax
filter ip ip-filter-id
filter ipv6 ipv6-filter-id
no filter [ip ip-filter-ip] [ipv6 ipv6-filter-id]
config>router>if>ingress
Context
config>router>if>egress
This command associates an IP filter policy with an IP interface.
Description
Filter policies control packet forwarding and dropping based on IP match criteria.
The ip-filter-id must have been pre-configured before this filter command is executed. If the filter ID
does not exist, an error occurs.
Only one filter ID can be specified.
The no form of the command removes the filter policy association with the IP interface.
No filter is specified.
Default
ip ip-filter-id — The filter name acts as the ID for the IP filter policy expressed as a decimal integer.
Parameters
Page 162
The filter policy must already exist within the config>filter>ip context.
1 — 16384
Values
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
