Alcatel-Lucent 7450 ESS Series Configuration Manual page 461

This command configures a destination IP address range to be used as an IP filter match criterion.
Description
To match on the destination IP address, specify the address and its associated mask, 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 may also be used.
The no form of the command removes the destination IP address match criterion.
none
Default
ip-prefix — The IP prefix for the IP match criterion in dotted decimal notation.
Parameters
ipv6-address — The valid IPv6 prefix for the IP match criterion in dotted decimal notation.
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
ipv6-prefix-list — creates a list of IPv6 prefixes for match criteria in IPv6 ACL and CPM filter
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
mask — The subnet mask length expressed as a decimal integer.
netmask — Any mask epressed in dotted quad notation.
dst-port
dst-port {lt | gt | eq} dst-port-number
Syntax
dst-port range dst-port-number dst-port-number
no dst-port
config>filter>ip-filter>entry>match
Context
config>filter>ipv6-filter>entry>match
This command configures a destination TCP or UDP port number or port range for an IP filter match
Description
criterion. Note that an entry containing Layer 4 match criteria will not match non-initial (2nd, 3rd,
etc) fragments of a fragmented packet since only the first fragment contains the Layer 4 information.
The no form of the command removes the destination port match criterion.
Default none
lt | gt | eq — Specifies the operator to use relative to dst-port-number for specifying the port number
Parameters
7450 ESS OS Router Configuration Guide
0.0.0.0 — 255.255.255.255
Values
0.0.0.0 — 255.255.255.255
Values
policies.
policies.
characters are used, the string must be enclosed within double quotes.
1 — 32
Values
0.0.0.0 — 255.255.255.255
Values
match criteria.
lt specifies all port numbers less than dst-port-number match.
gt specifies all port numbers greater than dst-port-number match.
Filter Policies
Page 461