Table of Contents
Advertisement
Router Global Commands
next-hop [ip-address | ip-int-name] — Specifies the directly connected next hop IP address used to
indirect ip-address — Specifies that the route is indirect and specifies the next hop IP address used
black-hole — Specifies the route is a black hole route. If the destination address on a packet matches
disallow-igp — This value is valid only for indirect static routes. If set and if none of the defined
Page 112
•
If there are multiple static routes with the same preference but different metrics then the
lower cost (metric) route will be installed.
•
If there are multiple static routes with equal preferences and metrics then ECMP rules
apply .
•
If there are multiple routes with different preferences then the lower preference route
will be installed.
1
Default
0 — 65535
Values
reach the destination. If the next hop is over an unnumbered interface or a point-to-point
interface, the ip-int-name of the unnumbered or point-to-point interface (on this node) can be
configured.If the next hop is over an unnumbered interface, the ip-int-name of the unnumbered
interface (on this node) can be configured.
The next-hop keyword and the indirect or black-hole keywords are mutually exclusive. If an
identical command is entered (with the exception of either the indirect or black-hole
parameters), then this static route will be replaced with the newly entered command, and unless
specified, the respective defaults for preference and metric will be applied.
The ip-address configured here can be either on the network side or the access side on this node.
This address must be associated with a network directly connected to a network configured on
this node.
ip-int-name
Values
to reach the destination.
The configured ip-addr is not directly connected to a network configured on this node. The
destination can be reachable via multiple paths. The indirect address can only resolved from
dynamic routing protocol. Another static route cannot be used to resolve the indirect address.
The indirect keyword and the next-hop or black-hole keywords are mutually exclusive. If an
identical command is entered (with the exception of either the next-hop or black-hole
parameters), then this static route will be replaced with the newly entered command and unless
specified the respective defaults for preference and metric will be applied.
The ip-addr configured can be either on the network or the access side and is normally at least
one hop away from this node.
this static route, it will be silently discarded.
The black-hole keyword and the next-hop or indirect keywords are mutually exclusive. If an
identical command is entered (with the exception of either the next-hop or indirect parameters),
then this static route will be replaced with the newly entered command, and unless specified, the
respective defaults for preference and metric will be applied.
tunneling mechanisms (RSVP-TE, LDP or IP) qualify as a next-hop, the normal IGP next-hop to
32 chars max
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
