Reading Parameters
RGB Good Read Raising Time
Specifies the time it will take for the RGB good read to change the status from
an Off state to Brightness state.
See
"RGB Good Read Raising/Falling Time"
ming instructions.
Set RGB Good Read Raising Time
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
$CRBRT
00 = No time
DEFAULT
Enter/Exit Programming Mode
on page 243 for more detailed program-
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Appendix D,
~
97