Datalogic RIDA DBT6400 Product Reference Manual page 252

References
RGB Good Read Holding Time
This parameter specifies the time it will take for the RGB good read to change
the status from an Off state to Brightness state.
The delay can be set within a range of zero (0) to 255 milliseconds (25.5 sec-
onds) in 100ms increments. A setting of zero specifies no delay.
To set the time:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Go to
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure. See the following table for examples of how to
set this feature.
Table 14. RGB Good Read Holding Time Examples
STEP ACTION
1 Desired Setting
2 Divide by 100
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT RGB GOOD READ HOLDING TIME
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
244
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
ming Mode.
page 99 and scan the bar code: SELECT RGB GOOD READ HOLDING
TIME.
represent the duration which was determined in the steps above.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
EXAMPLES
100ms
01
'0' and '1'
Appendix D,
200ms 1,000ms (1 sec.)
02 10
'0' and '2' '1' and '0'
Keypad, that
5,000ms (5 secs.)
50
'5' and '0'
RIDA™ DBT6400