Led And Beeper Indications - Datalogic RIDA DBT6400 Product Reference Manual

LED and Beeper Indications

The reader's beeper sounds and its LED illuminates to indicate various func-
tions or errors on the reader. An optional "Green Spot" also performs useful
functions. The following tables list these indications. One exception to the
behaviors listed in the tables is that the reader's functions are programmable,
and so may or may not be turned on. For example, certain indications such as
the power-up beep can be disabled using programming bar code labels.
Table 20. LED and Speaker Indications
Indication
Power-up Beep
Good Read Beep
ROM Failure
Limited Scanning
Label Read
Reader Active Mode
Reader Disabled
a
Green Spot flashes
momentarily
a.
Except when in sleep mode or when a Good Read LED Duration other than 00 is selected.
Product Reference Guide
Description
The reader is in the process
of powering-up.
A label has been successfully
scanned by the reader.
There is an error in the
reader' s software/program-
ming.
Indicates that a Host con-
nection is not established
when the USB interface is
enabled.
The reader is active and
ready to scan.
The reader has been disabled
by the Host.
Upon successful read of a
label, the software shall turn
the green spot on for the
time specified by the config-
ured value.
LED
Fast RGB loop for Top Led.
LED behavior for this indi-
cation is configurable via
the feature "Good Read:
When to Indicate".
Top Led Flashes.
N/A
a
Side LED is lit steadily .
Top LED blinks continu-
ously.
Upon successful read of a
label, the software shall
turn the green spot on for
the time specified by the
configured value.
LED and Beeper Indications
Beeper
Reader beeps four times
at highest frequency and
volume upon power-up.
The reader will beep once
at current frequency, vol-
ume, mono/bi-tonal set-
ting and duration upon a
successful label scan.
Reader sounds one error
beep at highest volume.
Reader ' c hirps' six times
at the highest frequency
and current volume.
N/A
N/A
N/A
275