Datalogic RIDA DBT6400 Product Reference Manual page 240

References
Enable Character
Specifies the value of the RS-232 host command used to enable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected.
NOTE
To set this feature:
Determine the desired character or value.
Character is not used (not available).
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING on
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 8. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from ASCII
2
Chart on page 303
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ENABLE CHARACTER SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
232
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
ASCII Chart on page 303
find the hex equivalent for the desired character/value.
page 32 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
Appendix D, Keypad, that represent the desired character/value determined
above. The second character will cause a two-beep indication.
Mode.
EXAMPLES
'e'
0x65
'6' and '5'
A setting of 0xFF indicates the Enable
on the inside back cover of this manual to
'}' 'E'
0x7D 0x45
'7' and 'D' '4' and '5'
page 32.
Enable Command
Not Used
0xFF
'F' and 'F'
RIDA™ DBT6400