1D Symbologies
Code 11 Set Length 2
This feature specifies one of the bar code lengths for
on page
page 164
Mode. Length includes the bar code's check and data characters.
The length can be set from 2 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See
more detailed programming instructions.
Select Code 11 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
04 = Length 1 is 4 Characters
DEFAULT
164. Length 2 is the maximum label length if in
Mode, or the second fixed length if in
$CC1L2
50 = Length 2 is 50 Characters
DEFAULT
Enter/Exit Programming Mode
Code 11 Length Control
Fixed Length on page 164
"Set Length 2"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Variable Length on
on page 250 for
Appendix D, Key-
~
165