Select Audio Jingle For Enter Base Station - Datalogic RIDA DBT6400 Product Reference Manual

Reading Parameters

Select Audio Jingle for Enter Base Station

This parameter selects which preloaded Jingle to use in indicating an Enter Base
Station event.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
(1-15) will be sounded when the scanner enters Base Station.
$CAUEM
Select Audio Jingle on Enter Stand Mode
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
Product Reference Guide
"Audio Jingle Enable" on page 82 must be selected for this configuration
item to take effect.
NOTE
™
configuration utility, use this setting to designate which of the Jingles
The capability to download Audio jingle require Datalogic Aladdin™ configu-
ration software, for this reason it is possible only if the reader is used with
the base station.
NOTE
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
00 = Use built-in Enter Base Station indication
Enter/Exit Programming Mode
Appendix D,
~
CANCEL
85