Code 93 Set Length 2 - Datalogic RIDA DBT6400 Product Reference Manual

Enter/Exit Programming Mode

Code 93 Set Length 2

This feature specifies one of the bar code lengths for
on page
page 184
Mode. Length includes the bar code's check, data, and full-ASCII shift charac-
ters. The length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See
more detailed programming instructions.
Select Code 93 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
186
184. Length 2 is the maximum label length if in
Mode, or the second fixed length if in
$CC9L2
50 = Length 2 is 50 Characters
DEFAULT
Code 93 Length Control
Fixed Length on page 184
"Set Length 2"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Code 93
Variable Length on
on page 250 for
Appendix D, Key-
~
RIDA™ DBT6400