1D Symbologies
Standard 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for
Control on page
Length on page 167
page 167
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See
more detailed programming instructions.
Select Standard 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
167. Length 2 is the maximum label length if in
Mode, or the second fixed length if in
Mode. Length includes the bar code's check and data characters.
$CS2L2
50 = Length 2 is 50 Characters
DEFAULT
Enter/Exit Programming Mode
Standard 2 of 5 Length
"Set Length 2"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Variable
Fixed Length on
on page 250 for
Appendix D, Key-
~
169